Ricoh Aficio SP 4110N - Manual (Page 147)

9. Troubleshooting
Error & Status Messages on the Control Panel
This section describes the main messages that appear on the display. If a message that is not described
here, follow its instructions.
Status Messages
Ready
This is the default ready message. The machine is ready for use. No action is required.
Processing...
The machine is printing. Wait a while.
Waiting...
The machine is waiting for the next data to print. Wait a while.
Offline
The machine is offline. To start printing, switch the machine to online by pressing the [Online] key on the
control panel.
Warming up...
The printer is warming up or toner is being supplied. Wait until "Ready" appears on the display.
Resetting Job...
The machine is resetting the print job. Wait until "Ready" appears on the display.
Setting change in process
The machine is changing settings. Wait a while.
Suspending...
All jobs in the machine are suspended. Wait a while.
Hex Dump Mode
In the hex dump mode, the machine receives data in hexadecimal format. Turn off the machine after printing,
and then turn back on.
Messages (in alphabetical order)
Call Service: EC Power Off On/Call Service if error reoccurs
A communication error was sent from the engine to the controller.
• Turn the power off, and then on. If the message appears again, contact your sales or service
representative.
145
9