Ricoh Aficio SP 4110N - Manual (Page 19)

2. Installing Options
Available Options
This section describes how to install options.
By installing options, you can improve the printer performance and have an expanded variety of features
to use.
• Before installing options, the machine should be turned off and unplugged for at least an hour.
Components inside the machine become very hot, and can cause a burn if touched.
• Before moving the machine, unplug the power cable from the outlet. If the cable is unplugged abruptly,
it could become damaged. Damaged plugs or cables can cause an electrical or fire hazard.
• When lifting the machine, use the grips on both sides. The machine could break or cause an injury if
dropped.
• The voltage rating of the connector for options is 24 V DC or less.
Option List
The following is a list of options for this printer.
• Paper Feed Unit TK1030
• Envelope Feeder Type 400
• AD1000 (Duplex Unit)
• Memory Unit Type C 128MB/ 256MB
• IEEE 802.11b Interface Unit
• Gigabit Ethernet Board Type A
• Hard Disk Drive Type 2650
• VM Card Type D
• Data Storage Card Type A
Option Installation Flow Chart
Installing multiple options in the following order is recommended:
17
2