Ricoh Aficio SP 4110N - Manual (Page 150)

IEEE 802.11b card access failure.
• Turn the power off, and then on. Remove and re-install the IEEE 802.11b interface unit or interface
unit correctly. If the message appears again, contact your sales or service representative.
• See p.33 "Attaching IEEE 802.11b Interface Unit".
Invalid Password Try again
The invalid password was entered and Locked or Stored Print is incorrect.
• Enter the correct password.
Irregular Toner
Irregular toner is set.
• Replace the toner to appropriate one.
Load Correct Size Paper/Paper Size: Paper Type: Press # to continue/Paper Size: Paper Type:
The paper size setting on the tray differs from that of actual paper size in the tray.
• Change the paper size of the tray where the error has occurred using dial or press the [Form Feed]
key. Printing will start again after pressing the [ Enter] key.
• See p.85 "Loading Paper".
Load Paper:Tray# or Form Feed
No paper remaining in the indicated tray.
• Load the indicated tray with the paper or select another tray using the [Form Feed] key, or cancel the
job.
Menu Protected Cannot change
The control panel has been digitally locked, and settings cannot be changed.
• This alert message is displayed for 3 seconds before returning to the previous display screen.
No Files exist
There are no files available for deleting or printing.
• Check the error list to identify the files unavailable for printing.
P=XX I=XXXXXXXX Power Off On/Call Service if error reoccurs
Controller error. The SC number indicates the problem.
• Turn the power off, and then on. If the message appears again, contact your sales or service
representative. Report the error code that appears.
Proxy setting or connection error
Proxy address port No. is invalid. Proxy is not active. Invalid center URL is set. Center is not active. Proxy
is not set.
• Check the proxy settings.
9. Troubleshooting
148
9