Poweramp POWERSTOP SERIES - Manual (Page 34)

32
4111-0014 — July 2013
NOTES
Item Quantity Part Number Description
A 1 1751-0880 Placard Vehicle Restraint
DANGER !
1.262.255.1510 or 1.800.643.5424
Call for additional placards, or manuals, or with questions
regarding proper use, maintenance, and repair of dock leveler.
www.
DockSystemsInc
.com
! Read and follow all instructions, warnings and maintenance schedules in
the manual and on placards.
! Vehicle restraint operation and servicing is restricted to trained personnel.
1
Before using the vehicle restraint:
! Remove any debris, snow or ice that may obstruct vehicle restraint
operation.
! Alert personnel in the area of potential vehicle restraint operation and
ensure area is clear.
! Operate the vehicle restraint thru one complete cycle, inspecting it for
proper operation and light sequence. Advise maintenance personnel of
any damage or improper operation immediately. Remove all
malfunctioning or damaged vehicle restraints from service using
approved lockout/tagout procedures.
2
Before attempting to restrain a transport vehicle:
! Verify that transport vehicle is positioned squarely against dock
bumpers
! Inspect the transport vehicle’s rear impact guard (RIG). Damaged or
missing RIGs may not allow the vehicle restraint to securely capture the
RIG. Wheel chocks must be used whenever the ability for the vehicle
restraint to capture the RIG is in question.
(NOTE: The transport
vehicle’s suspension and load condition will effect trailer height.)
3
After activating vehicle restraint:
! Verify that the transport vehicle’s RIG has been restrained successfully.
In the event this cannot be determined use wheel chocks in addition to
restraint.
! If equipped with a light communication package load and unload on
GREEN light only.
4
Maintenance or service must be performed by authorized personnel only.
Follow approved lockout/tagout procedures.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN DEATH OR OTHER SERIOUS
INJURY.
O P E R A T I N G
INSTRUCTIONS
1751-0880
VEHICLE RESTRAINTS
ENGAGE RESTRAINT
1
Open overhead door and visually check that
truck is positioned squarely against dock
bumpers and has a RIG bar. Inside light is
RED and outside light is GREEN.
2
Depress the ENGAGE button to activate
restraint.
3
Once RIG has been secured inside light is
GREEN outside light is RED
RELEASE RESTRAINT
1
To release truck restraint depress the
RELEASE button. When safely stored inside
light is RED and outside light is GREEN.
BY-PASS
1
If restraint is unable to secure transport
vehicle’s RIG, use wheel chocks to secure
transport vehicle at the dock.
2
Turn switch to BY-PASS. Inside light is
GREEN outside light is RED.
3
L o a d i n g / u n l o a d i n g m a y p r o c e e d w i t h
caution.
BY-PASS RESET
(RETURN TO NORMAL OPERATION)
1
When loading or unloading is completed,
and wheel chocks are removed, manual
reset of BY-PASS is accomplished by
depressing the RELEASE button or turning
switch to NORMAL. Lights change to RED
inside GREEN outside.
Use with PowerHook, Powerhold, Holdtite and TPR series
A