Poweramp POWERSTOP SERIES - Manual (Page 6)

4
4111-0014 — July 2013
SAFETY
Maintenance Safety Precautions
Hydraulic and electrical power must be OFF when
servicing the equipment. For maximum protection,
use an OSHA approved locking device to lock
out all power sources. Only the person servicing
the equipment should have the key to unlock the
device.
ALWAYS disconnect electrical power source and
ground wire before welding on dock leveler.
DO NOT ground welding equipment to any
hydraulic or electrical components of the dock
leveler. Always ground to the dock leveler frame.
Failure to follow these instructions may result in
damage to dock leveler and/or serious personal
injury or death.
ALWAYS stand clear of dock leveler lip when
working in front of the dock leveler. Failure to do
this may result in serious personal injury or death.
DO NOT grind or weld if hydraulic fluid or other
flammable liquid is present on the surface to be
ground or welded
DO NOT grind or weld if uncontained hydraulic
fluid or other flammable liquid is present. Stray
sparks can ignite spills or leaks near the work area.
Always clean up the oil leaks and spills before
proceeding with grinding or welding.
Always keep a fire extinguisher of the proper type
nearby when grinding or welding.
Failure to follow these instructions may result in
serious personal injury or death.
Always post safety warnings and barricade
the work area at dock level and ground level
to prevent unauthorized use of the unit before
maintenance is complete.
Access under the dock leveler may be required
to service the vehicle restraint. The maintenance
prop must be in the upright “service” position when
working under the dock leveler. For maximum
protection, use an OSHA approved locking device
to lock the maintenance prop in the service
position. Only the person servicing the equipment
should have the key to unlock the device.
1.50"
3
.0
0
"
Control Box Size: Overlay
Decal Size: 1.5 x 3
File Name: 1751-0736
DANGER
Hazardous Voltage
Will Cause Severe
Injury or Death
Arc Flash and
Shock Hazard
PPE (Personal Protection
Equipment) Required
De-energize equipment before
working on or inside. Do not
open cover without appropriate
PPE. Refer to NFPA 70E for
PPE requirements. This panel
may contain more than one
power source.