Third, unplug the ethernet cable – PROLiNK PIC1005WN User Manual User Manual
Page 9
EN 6
2.3.3. Third, unplug the Ethernet cable
If the WiFi test is successful, you can then enable
the WiFi connection by unplugging the Ethernet
cable from the IP Camera. The IP Camera will detect
the Ethernet cable unplugged condition and start
the WiFi connection. After the WiFi is connected,
the IP Camera will connect to the Internet
immediately.
Figure 2-8: Unplug the Ethernet cable to enable
the WiFi function
Notice
1. Please remember that the WiFi connection will use a different IP address, you will need to do the
“Auto Search” function in the LiveView again to find the IP Camera again after the WiFi is connected.
2. If you want to switch back to the wired Ethernet connection, just plug in the Ethernet cable into the
IP Camera again. Do not need to disable the WiFi function on the web pages.