Victory RS-2N-S7-FF (Manufactured after4-19-10) - Manual (Page 5)

iii
Proper installation is the first step to operation. We recommend that your refrigerator or freezer
be installed by an authorized Victory Certified Installer.
Receiving Shipment
All units are performance tested and thoroughly inspected prior to shipment. Upon leaving the
factory, all units are in perfect condition. Upon receipt, examine the exterior of the shipment
packaging for any signs of rough handling. If the cabinet is damaged, it should be noted on the
delivery slip or bill of lading and signed. A claim must be filed immediately against the carrier
indicating the extent and estimated cost of damage incurred.
Uncrating
Tools Needed : 3/4” Box Wrench, Adjustable Wrench, Level
WARNING: Never lay your refrigerator or freezer down on either its back, front or sides. This
allows compressor oil into the refrigerant lines which can damage the compressor at start-up. If
the unit is laid down, it must be set upright for a minimum of 12 hours before starting the
compressor. Failure to adhere to the above recommendation will void the warranty.
1. Split plastic wrap along one of the cardboard posts. Remove and discard all packaging
material, tape and interior components.
2. Move cabinet as close to final location as possible before removing skid.
3. Remove the shipping skid by tipping the cabinet forward. Remove the shipping bolts with
3/4” box wrench while the cabinet is held in one direction. Repeat this procedure
while the cabinet is held in the opposite direction.
4. Use extreme caution when removing the wooden skid, especially when the last bolt is
removed. If not properly blocked, the skid will fall to the floor.
Locating Your New Storage Refrigerator or Freezer
Consider the following when selecting a location for your refrigerator or freezer:
1. Clearance - There must be a minimum clearance of 10” between the top of the refrigerator
or freezer and the ceiling.
2. Floor Load - The floor on which the cabinet will rest must be free of vibration and suitably
strong enough to support the combined weights of the cabinet plus the maximum product
load.
3. Ventilation - The air cooled, self-contained refrigerator or freezer requires a sufficient
amount of cool, clean air. Avoid placing the refrigerator or freezer near heat generating
INSTALLATION INSTRUCTIONS