Electronics International UBG-16 - Manual (Page 10)

6
4. 4. 4. 4. 4. "UBG-16" "UBG-16" "UBG-16" "UBG-16" "UBG-16" Configuration Form: Configuration Form: Configuration Form: Configuration Form: Configuration Form:
If you are installing the UBG-16, fill out the following configuration form. This form will document which
Temperature probes or Functional Modules will be connected to specific input channels on the UBG-16.
LEFT
8-Input Channels
RIGHT
8-Input Channels
1 to ______ EGTs
(BAR 7) TIT, Oil T, OFF
L________ __________
L________ __________
L________ __________
L 8 __________
LEFT
Channels: Function: Comments:
Up to 7 channels may be used to monitor EGTs. Each channel will be
displayed on a column of bars. A total of 7 columns are available. Enter
the number of EGTs you will be monitoring.
The 7th column of bars is intended to display EGT (on a 7-cylinder engine)
or TIT or Oil Temp or it may be turned off (circle one). However, the TIT
or Oil Temp probe must be connected to the next channel after the last
EGT channel (e.g., #5 on a 4-cylinder engine or #7 on a 6-cylinder engine).
In order, list the unused channels on the LEFT connector and indicate the
functions to be monitored on each channel. OAT or Carb Temp must only
be connected to channel L7, L8, R7 or R8 (these are precision channels). If
a channel is not used, write "OFF" in the Function Column for that channel.
Channel 8 is the last available channel on the left.
Right
Channels: Function: Comments:
1 to ______ CHTs
R________ __________
R________ __________
R________ __________
R 8 __________
The number of CHTs monitored must be the same as the number of
EGT's monitored. The CHTs are monitored on the RIGHT Channels.
Enter the number of CHTs you will be monitoring.
In order, list the unused channels on the RIGHT connector and indicate
the functions to be monitored on each channel. OAT or Carb Temp
must only be connected to channel L7, L8, R7 or R8 (these are precision
channels). If a channel is not used, write "OFF" in the Function Column
for that channel.
Channel 8 is the last available channel on the Right.
Note: The UBG-16 digital display steps through the channels starting with number one on the LEFT and ending
with number 8 on the RIGHT.