Electronics International UBG-16 User Manual

Page 4

Advertising

P-110 F

-110 F

-110 Fast Response EG

ast Response EG

ast Response EGT Probe

T Probe

Important Installation Information

All steps

All steps must

must

must be read before installing a probe.

be read before installing a probe.

0720921





Note: The tab inside the male connector must be centered (not
bent up or down) to mate properly. Check each connector before
installation. Two drops of oil on the connector will protect it
from corrosion for many years.

Note: If you remove a connector, double over the wire
before installing it into a new connector. Each connector
must be double crimped very tightly.

Male Conn.

Note: If connectors have been disconnected several times the female connector may become
loose. If this happens use a pair of needle nose pliers to retighten the female receptacle
then mate the connectors.

Note: Leave slack in the
cable to allow for engine
movement and vibration.

1. Drill a .130" hole in the exhaust pipe.
Location is described in the manual.

3/8"

Ferrule

Note: Do Not Overtighten.
Over time, tight wire wraps will
cause the wire to break.

2. The slit in the ferrule must be
placed perpendicular to the Band
and the spring must be 3/8" back
from the ferrule.

Band

3. If the probe is placed in a
hole larger than .130", use a
S.S. washer between the exhaust
pipe and the ferrule.

Advertising