Electronics International UBG-16 - Manual (Page 3)

Important Installation Information Important Installation Information Important Installation Information Important Installation Information Important Installation Information
0720921
1. Leave slack in the cable to allow
for engine movement and vibration.
All steps All steps All steps All steps All steps must must must must must be read before installing a probe. be read before installing a probe. be read before installing a probe. be read before installing a probe. be read before installing a probe.  
2. Do Not Overtighten.
Over time, tight wire wraps
will cause the wire to break.
Hose Clamp.
4. The tab inside the male connector must be centered (not bent
up or down) to mate properly. Check each connector before
installation. Two drops of oil on the connector will protect it
from corrosion for many years.
5. If you remove a connector, double over the wire
before installing it into a new connector. Each connector
must be double crimped very tightly.
Male Conn.
6. If connectors have been disconnected several times the female connector may become
loose. If this happens use a pair of needle nose pliers to retighten the female receptacle
then mate the connectors.
S.S. Washer.
3. Both clip rings must be on the
inside of the hose clamp.
The rubber band is used to hold
the washer on during shipping.