Electronics International UBG-16 User Manual
Page 16
13
High and low EGT and CHT limits may be set for each cylinder displayed on the UBG. When operating in
the Normal Mode only
Normal Mode only
Normal Mode only
Normal Mode only
Normal Mode only, the EGT and CHT limits may be set by performing the following steps:
A.
A.
A.
A.
A. Select the cylinder on which the limits are to be programmed.
B.
B.
B.
B.
B. Press and hold the mode switch to the left until the word “PROGRAM” appears in the digital display.
Release the Mode Switch. “SET H” will appear on the left side of the UBG display. Also, “EGT” will
appear in the left portion of the digital display and the right
portion will show the current high limit. The digit on the far
left will be blinking.
C.
C.
C.
C.
C. Use the Step Switch to increase or decrease the digit which is
blinking. The EGT Limits can be set from 0 to 1990’F in 10’F
increments and the CHT Limits can be set from 0 to 499’F in 1’F
increments (although the CHT limit will be converted down to an
even number).
D.
D.
D.
D.
D. Use the Mode Switch to blink a specific digit.
E.
E.
E.
E.
E. To change functions, push the Mode Switch to the right (or left) until the digital display shows the
function you wish to program. The functions will appear in the following order:
1.
1.
1.
1.
1. EGT High Limit.
2.
2.
2.
2.
2. EGT Low Limit.
3.
3.
3.
3.
3. CHT High Limit.
4.
4.
4.
4.
4. CHT Low Limit.
5.
5.
5.
5.
5. Upper EGT Bar Trip Point (programmed on cylinder #1 only).
6.
6.
6.
6.
6. Lower EGT Bar Trip Point (programmed on cylinder #1 only).
Note:
Note:
Note:
Note:
Note: Setting a limit to “000” will disable the limit and any alarms.
F.
F.
F.
F.
F. To exit this programming mode, push and hold the Mode Switch to the left until the word “END”
appears in the digital display.