FEC AFC1200 - Manual (Page 14)

)(& ,QF
5. Follow all safety precautions to install the UPC PCB in reverse order of removal.
6. Verify that power is off, and disconnect any component cables connected to the FC386
PCB. Remove the two (2) screws holding the FC386 PCB face plate (on front of the Main
Unit), and pull out straight to remove the PCB.
7. Locate the RDISK daughter board installed at the approximate center of the FC386 PCB.
Remove the two (2) screws from the RDISK daughter board that are connecting it to the
FC386 PCB. Reinstall the FC386 PCB (without the RDISK daughter board) to enable
System boot-up from Drive A: (FDD1).
8. Place Disk 1 of MSDOS 5.0 (or later version) into Drive A: (FDD1). The disk must be a
self-booting disk with MSDOS "FDISK" and "FORMAT" utility programs.
9. Perform 8.3.5 CMOS Setup.
10. Perform MSDOS "FDISK" utility program (A:FDISK). Follow instructions on the System
monitor to designate the HDD as logical Drive C: without partitions (other than the
primary DOS partition).
11. When "FDISK" is complete, then format drive C: (A:FORMAT C:) Remove the MSDOS
disk when formatting is complete.
12. Insert the disk containing the file "#OPTION1.SYS" into the Drive A:, and copy the file
(A:COPY #OPTION1.SYS) into the Drive C: root directory. This file redirects the boot
sequence to the RDISK daughter board on the FC386 PCB (logical Drive D:). The file
contains the following:
SHELL=D:\COMMAND.COM D:\ /P /E:512 After the file is
copied to Drive C:, remove the disk from Drive A:
13. Remove the FC386 from the Main Unit. Reinstall the RDISK daughter board onto the
FC386 PCB with two (2) screws, then reinstall the FC386 PCB into the Main Unit.
14. Verify there are no disks in Drive A: and reconnect any cables removed in Step 1.
15. Power up the System. The System will now boot from the RDISK board (D:) directly into
the AFC1200 program.
WARNING:
DO NOT CONNECT OR DISCONNECT CABLES OR OTHER SYSTEM
COMPONENTS WITH POWER APPLIED.
8.3.8 FDD Addition/Replacement (Part of Main Unit / UPC PCB)
When a new Floppy Disk Drive (FDD) is introduced (added or replaced) into the System,
CMOS setup must be completed as outlined in 8.3.5 CMOS Setup.
1. Ensure the power is off. Disconnect any component cables connected to the UPC PCB.
Remove the three (3) screws holding the UPC board face plate (on front of Main Unit),
and pull out straight to remove the PCB.
2. Verify that the FDD to be installed is either a TEAC Model FD-05HF or other compatible
3.5 inch, 1.44 MB, Notebook type drive.
3. Install the drive into the designated location ("FDD1" Drive A: or "FDD2" Drive B: as shown
on the front of the UPC PCB face plate). Connect the flat ribbon cable to the UPC PCB
connector labeled FDD1 or FDD2, as appropriate.
4. Follow all safety precautions to reinstall the UPC PCB into the Main Unit.
5. Perform 8.3.5 CMOS Setup.
8.3.9 Axis Unit Replacement (No Partial Replacement - Complete Unit Only)
When one Axis Unit is being replaced with another, it is important to verify that both Units are
the same Type. (Refer to Section 2.4 Axis Unit and to the chart, below.)
Chapter 8: Maintenance and Inspection User Console Version A3.53
Page 8-14