FEC AFC1200 - Manual (Page 7)

)(& ,QF
transmission housing with excessive grease; overgreasing could damage the tool.
Recommended grease: Sunoco Sunaplex 992 EP or equivalent.
6. REASSEMBLE TRANSMISSION. Refer to the appropriate transmission assembly
drawing while reassembling the transmission. If needed, rotate the gears to aid in the
assembly process. If the transmission does not rotate freely after reassembly, then
disassemble the transmission again to isolate and correct the cause.
7. REASSEMBLE TOOL. Connect the transmission to the motor with four (4) screws. If
needed, rotate the output shaft to align the transmission planetary gears with the motor
output splined shaft. Connect the transducer to the transmission with four (4) screws.
Install the snap ring onto the output shaft to hold the outer bearing in place. If the
transmission does not rotate freely after reassembling the tool, then disassemble the tool
again to isolate and correct the cause.
NOTE: Snap ring installation must be the last step in reassembly.
8. INSPECT SPINDLE ASSEMBLY. Prior to installing the tool into an application, inspect
the spring loaded spindle assembly that will connect to the tool. The assembly should
compress evenly, without binding. Rotate the assembly in the spindle housing and verify
there is no binding. Visually inspect the entire assembly for signs of wear or fatigue.
Replace parts as required, and reassemble. Lubricate the inner bearings of the housing
as required, and reinspect the final assembly. Install the tool into the application and verify
there is no binding.
Chapter 8: Maintenance and Inspection User Console Version A3.53
Page 8-7