FEC AFC1150 - Manual (Page 17)

)(& ,QF
4.7 tool connection
w Connect the encoder cable and the
motor cable to the corresponding
numbered tool. Ensure that the cable
tag numbers match the tool tag
numbers.
w Be sure that the cable is tied so that
there is no undue stress on it when
the powerhead moves.
IMPORTANT! When the powerhead
contacts a hard stop, the shock
(vibration) may damage the tool,
especially in short cycle time
applications. FEC INC. highly
recommends the use of shock
absorbers or cylinder cushions to
appropriately decelerate the tool.
FIG: 4.7-A Tool Mounting Diagram
Fig. 4.7-B Tool Mounting Methods
CHAPTER 4: INSTALLATION AND WIRING
Page 4 - 17