FEC AFC1150 - Manual (Page 7)

)(& ,QF
4.4 Power Requirements and Connection
IMPORTANT!!
DO NOT CONNECT POWER SOURCE UNTIL THE POWER UP CHECKLIST HAS
BEEN COMPLETED!
REFER TO CHAPTER 5 FOR PRE-POWER UP REQUIREMENTS.
WARNING!!
VERIFY SYSTEM POWER IS OFF PRIOR TO CONNECTING OR
DISCONNECTING CABLES.
Using the supplied cable, connect the power source to the MIL-STD type connector located
on front of the controller.
Fig. 4.4
WIRING:
Frame Ground
(F. GND or FG) D
W phase C
V phase B
3 Phase
200-230 VAC
+/- 10%
50-60 Hz U phase A
INPUT POWER LINE PIN
CHAPTER 4: INSTALLATION AND WIRING
Page 4 - 7
AC IN
POWER
NORMAL
IN BYPASS
A
B C
D
CONTROLLER
AFC1150 SYSTEM
AC200~230V
POWER
CONNECTOR