FIREPOWER MXL-IQ - Manual (Page 3)

MPS-6
CSM-4 Controllable Signal Module
The Controllable Signal Module CSM-4 provides two fully
supervised, programmable notification appliance circuits.
The CSM-4 supplies two Class B (Style Y) or Class A
(Style Z) type output circuits for the supervision and
control of listed audible or visual notification appliances
such as horns, bells, strobes, etc. Each circuit can provide
up to 1.5 Amps (24 VDC) of current to power notification
appliances. CSM-4 is also used for pre-action or deluge
application as well as for applications that call for municipal
tie or leased line operation. Sinorix TM and Halon cylinder
solenoid activation is also controlled by the CSM-4.
CZM-4 Conventional Zone Module
The Conventional Zone Module CZM-4 is used with the
MXL-IQ to provide four Class A (Style D) or Class B (Style
B) conventional initiating device circuits. Each circuit can
monitor up to 30 Siemens Building Technologies, Inc. Fire
Safety two wire photoelectric or ionization smoke detectors
and an unlimited number of normally open contact devices.
Projected Beam Detectors may also be used. The CZM-4
circuits will support the use of detector relay bases, and
remote indicator lamps. Activation of any device on a circuit
will initiate a zone alarm condition resulting in the operation of
programmed functions. The CZM-4 module plugs into one
full slot in the MOM-2 or MOM-4 expansion card cage.
CSM-4
CRM-4 Controllable Relay Module
The Controllable Relay Module CRM-4 is designed to
provide auxiliary control of building functions such as door
holder release, elevator capture, smoke control, lock
release, etc. The CRM-4 plugs into one of the slots in the
CRM-4
CZM-4
CMI-300 CXL/MXL Interface Module
The CMI-300 is an MXL-IQ option module which provides
modem communication between an MXL-IQ and a CXL
system. The CMI-300 plugs into one of the slots on a
MOM-2 or MOM-4 card cage. This interface board trans-
lates signals between the MXL-IQ and the CXL and fully
supervises the signals.
CMI-300
MPS-12 Power Supply
The MPS-12 is a fully supervised power supply which
provides the system with primary DC power. It is rated
at 12 Amps. and is unfiltered and unregulated. It supplies
the MXL-IQ Control Unit and their expansion modules
with power required for normal operation. The unit
incorporates a resettable circuit breaker on the primary
input and includes a built-in AC line filter for surge and
noise suppression. The MPS-12 mounts in the MXL
enclosure backbox.
MOM-2 or MOM-4 expansion card cage. It provides four
fully programmable relays. Each relay contains one set of
SPDT contacts rated at 2 Amps 30 VDC/120 VAC resistive.
MPS-12