Darex XT-3000A - Manual (Page 65)

63
The Auto Sharpening Attachment comes
equipped with a sharpening fixture, a
Controller/Display and a chuck/chucks.
Available chuck options listed below. The
Automated Sharpening System is for
use with the XT-3000 Expandable
Tool Sharpener only and not for use
with other sharpeners.
LEX400 - 115v w/3-12mm Chuck
LEX400I - 230v w/3-12mm Chuck
LEX450 - 115v w/12-21mm Chuck
LEX451I- 230v w/12-21mm Chuck
LEX500 - 115v w/3-21mm Chucks
LEX500I- 230v w/3-21mm Chucks
1. Remove from shipping box and re-
move all packaging material.
2. Attach sharpening fixture to XT base,
making sure the sharpening fixture is
secure. For more information on
mounting the sharpening fixture, see
page 9.
3. Attach Controller/Display with mount-
ing bracket provided, see page 10.
4. Connect DIN cable from sharpening
fixture to Controller/Display, see page
12.
5. Connect power from outlet source to
back of Controller/Display inlet, see
page 13.
6. Connect Pigtail Jumpers from the
back of Controller/Display to XT-3000
Base casting inlet. For detailed set up
information, see page 13.
7. The accessory receptacle is located at
the top of the power receptacle on th
e
back of the Controller/Display and wi
ll
allow you to use a dust extraction sys-
tem in conjunction with the use of th
e
XT3000. *We highly recommend
the use of a vacuum when the
machine is in use.
8. Make sure the grit tray is in place and
secure.
9. Un-box the chuck.
10. Align and secure the drill in the chuck.
(See XT-3000 Instruction Manual
PP16180KF for Alignment details)
11. Insert chuck into Sharpening fixture.
Secure chuck in sharpening fixture.
12. Power on the machine by pushing the
rocker switch into the ON position, this
will immediately start the grinding
wheel in motion and power up the
Controller/Display screen.
13. Set up the LCD screen on the Control-
ler/Display, see pages 15-18.
14. (THIS STEP IS NOT NECESSARY
WHEN PURCHASING AND XT-3000
A COMPLETE) Calibrate Final Grind -
Drill Stick Out on sharpening fixture, see
pages 20-21.
15. Press Start on the Controller/Display
screen to begin sharpening. NOTE: The
sharpening fixture will immediately be-
gin to rotate and sharpen the drill. Make
sure hands and clothing are free of the
sharpening fixture.
16. Once the chuck has stopped, release
the chuck and remove from sharpening
fixture.
17. If a split point drill is desired, insert
chuck into splitting port. DO NOT re-
move drill from chuck until split is com-
plete. (See XT-3000 Instruction Manual,
PP16180KF, for Split Point details)
Quick Start Set Up