Direct Lift Pro9F - Manual (Page 10)

Pro9F 9000 lbs. Floor Plate Lift IN50019 Rev. C 03/30/2009 10
STEP 10
: Installing the equalizing cables: (see diagram below) Loosen the two Cable Retaining
Bolts as shown. Route the first cable as shown. Tighten nut on one cable stud so that the end
of stud passes the nylon on the nut. Pull the other end of cable and run nut on it. Repeat above
for second cable. Once installed tighten the Cable Retaining Bolts.
NOTE: DO NOT tighten cables at this time. Just start them on the threads.
Cable
3/4” Nylon Insert Locknut
(Columns Not Shown For Clarity)
Pulley
Cable Retaining Bolt
Cable Retaining Bolt
Pulleys
Ø20 Washer
Ø20 Washer
3/4” Nylon Insert Locknut
Cable
Carriage