Direct Lift Pro9F User Manual
Page 12
Pro9F 9000 lbs. Floor Plate Lift
IN50019 Rev. C 03/30/2009
12
STEP 13
: Mount the Power Unit on lift as shown.
STEP 14
: Mount the Floor Plate as shown below. Drill 3/8" holes using holes in plate as guides.
Following drill steps/directions used when anchoring columns. Tighten to 25 ft-lbs.
Floor Plate
3/8” Anchor
STEP 15
: Install the swing arms on the carriages using the included 1-1/2" diameter pins. Check
for proper engagement of the arm lock – the teeth on the lock should fully engage the gear on
the arm. Note, if arm pins are not fitting, you will need to pull up on arm lock to allow slack for
the arm to move around in the carriage, allowing the arm pin to fit easier.
STEP 16
: Adjust the carriage cables tension. Adjust each cable to approximately 1/2" side-to-
side play. Check the latch releases to insure the carriage is still sitting on the appropriate latch.