Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 95)

Section 3: Access Terminal Screens Defined
01/13 95 51299 Rev. 1
3.3.5. Rfid Reader Setup, Continued
TransCore Readers
Command Timeout: Enter a command timeout in milliseconds. Default is 2500 ms.
Use Predefined Outputs: There are two options for using the outputs on the
Transcore reader.
1.) Use the predefined behavior of the outputs (turning this option on). In this
case the reader will control the outputs and the Access terminal will only be
able to monitor the outputs.
2.) Direct control of the outputs by the terminal (turning this option off). In this
case the Access terminal will be able to control the outputs. This does require
configuring a remote IO source on the Input/Output Setup page. Just select
TransCore IO and select the reader slot the the TransCore reader is
configured in.