Fairbanks H90-5200-A Digital Instrument User Manual
Page 31
* All commands must be terminated by a <CR> and <ETX>. Upon receipt, the
command will be executed.
* The Command String (including the <CR> and <ETX>, and ID if required) may not
be longer than 20 characters. IF the string is longer than 20 characters, the extra
characters will be lost.
* If a Scale ID other than 0 (Section 2, B-13) has been entered, the Command
must be preceded by a 1-3 digit Scale ID or it will be ignored. If a Scale ID other than
0 has been entered and weight is outputted, the weight output string will be preceded
by a Scale ID String.
* Buffer will be cleared after command is executed.
* Computer commands may be echoed and /or acknowledged. Refer to Subsection I,
of this section for further information.
Example
Command
:
<STX>12P<CR><ETX>
Response
:
SCALE 12 <CR><LF>
Weight is output to all printer channels The following computer commands are
supported. Refer to Appendix V (Data Format) for output string information.
<STX>P<CR><ETX>
Weight is output to all printer channels
WEIGHT
<STX>W[L/K]<CR><ETX>
Weight is output to computer channel requesting data only L(LB)
OR K(KG) can be used to request output in specific weight unit
ZERO
<STX>Z<CR><ETX>
Scale is zeroed IF no motion
NET
<STX>N<CR><ETX>
Scale is switched to net mode IF tare is enabled
GROSS
<STX>G<CR><ETX>
Scale is switched to gross mode
AUTOTARE
<STX>A<CR><ETX>
Scale is Autotare IF Autotare is enabled
START
<STX>B<CR><ETX>
Batch cycle is started
STOP
<STX>S<CR><ETX.
Batch cycle is stopped
DISCHARGE
<STX>D<CR><ETX>
50515
31
Issue #2 4/04