Setting-up the system, Powering the system – General Tools and Instruments DCS400/DCS400-05/DCS400-09 v.1 User Manual

Page 11

Advertising
background image

SETTING-UP THE SYSTEM

Remove the pistol grip handle with attached probe from the
hard case. Then re-
move the wireless LCD
monitor. Attach the
monitor to the handle
by aligning the signal
connector slots (#1) on
the monitor with the
dual tabs (#2) on the
top of the handle
(Fig.4). Slide the moni-
tor to the left until it se-
curely engages the locking buckle clip (#3). (To remove the
monitor you need to depress the buckle clip and slide the
monitor to the right).

You are now ready to power ON the system or to charge the
system. When using the system don’t forget to remove the
camera’s protective cover (Fig.2 #5).

POWERING THE SYSTEM

To turn the monitor ON simply press the ON/OFF button on the top of the
monitor (Fig.5).

The pistol-grip handle (Fig.6) has a yellow thumbwheel
for ON/OFF control of the camera and to adjust the
brightness of the white LED lights at the end of the
camera head.

#3 Locking Buckle Clip

#1

Connector

Slots

#2

Dual

Tabs

Slide

Pistol Grip

Handle

Power Button

to Turn

Monitor
ON/OFF

Fig.5

Yellow Thumbwheel up to Turn On and down

to turn off Probe, Camera and LED Lights

Fig.6

11

Fig.4

Advertising