General Tools and Instruments GT310 - Manual (Page 18)

19. The reading on the DMMD_PCView screen will continue to
duplicate the contents of the GT310’s upper readout.
Receiving and Displaying Data from a Second GT310 or a GT320
To configure your GT310 to receive display measurements and
indications from another GT310 or a GT320 wireless multimeter, use
the Power/Tx/Rx/Ax button.
When the meter is powered on, the default setting is no
communication.
To enable transmission, briefly press the
Power/Tx/Rx/Ax button once. A
icon
will appear at the right of the upper readout
and the display will look like this:
To enable reception, briefly press the
Power/Tx/Rx/Ax button a second time.
The
icon will disappear and a will appear at the right of
the lower readout. In “receive only” mode, your GT310 will not display
any of its own measurements on the upper readout; it will only display,
on its lower readout, measurements from a second wireless
multimeter.
Immediately after you enable receive mode,
your GT310 will operate in “standby receive
mode” until you synchronize its receiving
channel with the transmitting channel of the
other meter. Before you synchronize the two
meters, the display will look like this:
After you synchronize the two multimeters,
the new display will duplicate the data
shown on the second meter and look like
this:
To match the receiving channel of your GT310 to the transmitting
channel of the second multimeter, press and hold the Hold/CH
button, and then press it briefly to cause the lower readout to show
CH-0. Quickly (within 10 seconds), press the Select/0-9 button as
many times as needed until the channel number on the lower readout
matches the transmitting channel number of the second multimeter.
18