Lighting instructions, Warning – King Kooker 2106 Heavy Duty Portable Propane Outdoor Smoker Package User Manual

Page 15

Advertising
background image

15

LIGHTING INSTRUCTIONS

THE SMOKER MUST NOT BE LIT UNTIL THE PRECEDING

PLACEMENT INSTRUCTIONS HAVE BEEN COMPLETELY FOLLOWED.

1.

Check the casting (steel burner) to make sure it is set up as per Figure 3 on page 10. Open the

main smoker door. Never light the burner with the smoker door closed. Never lean into the

smoker chamber while lighting. Locate the red plate embossed with HOT on the stack on top

of the cabinet. Turn the plate until it is fully exposed. This signals that the smoker is HOT while

in use.

2.

Make certain that the control knob on the smoker is turned to the OFF position.

3.

Open cylinder control valve by turning it counterclockwise as per the diagram (Figure 1).

4.

There are multiple ways of lighting your smoker. Choose one of the following methods:

A. Piezo Ignition - Push and turn the control knob towards the “HIGH” position. Immediately

press the red ignitor button next to the control knob repeatedly until ignition occurs (see

Figure 2). When lighting the smoker, if ignition does not occur in 3 to 5 seconds, turn the

control knob and cylinder valve off. Wait 5 minutes for gas to disperse. Repeat procedure.

B. Multi-Purpose Lighter/Paperbook Match - Push and turn the control knob towards the

“HIGH” position. Immediately place a lit multi-purpose lighter or paperbook match through

the hole on the side of the burner shroud as shown in Figure 3. When lighting the smoker, if

ignition does not occur in 3 to 5 seconds, turn the control knob and cylinder valve off. Wait 5

minutes for gas to disperse. Repeat procedure.

5.

Check that the flame is blue and that the flames are emitted completely around the burner (see

Figure 4). If there is a yellow flame, or if some ports have no flame, this indicates there may be

an obstruction in the venturi tube or ports. Check the maintenance instructions on page 17 for

more information regarding a yellow flame or blockage.

6.

Always monitor the flame throughout the cooking process. If at any point in the cooking process

the flame is accidentally extinguished, immediately turn the control knob and cylinder valve OFF.

Open main smoker door slowly, wait 5 minutes for gas to disperse and relight the smoker

according to the lighting instructions (#1-#5) in this section.

WARNING

Figure 1

Figure 2

Figure 3

Figure 4

Turn triangle tank handle

toward ON (Counterclockwise)

Advertising