Avaya 580 - Manual (Page 161)

Document No. 10-300077, Issue 2 5-19
Configuring SNMP
Table 5-8 defines the command keywords and variables.
Creating or Modifying a Community String for the ATM-
Uplink Module
To create or modify a community string to access the ATM-Uplink module,
use the following CLI command:
(configure)# snmp-server atm-community <community-string>
<slot> {ro | rw} [<ip-addr>]
Table 5-9 defines the command keywords and variables.
Table 5-8. snmp-server community
Field Definition
<community-
string> The name of the community string. The community
string can range from 1 to 26 characters.
Important: Do not assign a community string and
SNMPv3 user the same name.
<groupname> Name of the group to which you are assigning the
community string.
Important: Do not assign the community string to a
group that requires authentication or
encryption. Community strings do not
support authentication or encryption.
<ip-addr> The IP address from which the community string is
valid. Trap messages are sent to this IP address if you
enter the notify option.
[notify] Sends trap messages to the IP address that you specify.
Table 5-9. snmp-server community
Field Definition
<community-
string> The name of the community string. The community
string can range from 1 to 26 characters.
Important: Do not assign a community string and
SNMPv3 user the same name.
<slot> The slot number of the ATM Uplink module.
1 of 2