Avaya 580 - Manual (Page 162)

5-20 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 5
Viewing Configured Community Strings
To view the currently configured community strings, use the following CLI
command:
# show snmp community [<community-string>]
Setting the Trap Receiver
To set the trap receiver for a community string, use the following CLI
command:
(configure)# snmp-server notify <ip-addr> <community-string>
Table 5-10 provides an explanation of the command variables.
Deleting a Community String
Switch Community
String To delete a community string for the switch, use the following CLI
command:
(configure)# no snmp-server community <community-string>
[<ip-address>]
Table 5-11 provides an explanation of the command variables.
ro Assigns read-only access to the community string.
rw Assigns read-write access to the community string.
[<ip-addr>] The IP address from which the community string is
valid.
Table 5-9. snmp-server community
Field Definition
2 of 2
Table 5-10. snmp-server notify Command
Parameter Definition
<ip-addr> The IP address to which you want trap messages sent.
<community-string> The existing community string for which you are
setting the trap receiver.