Ransburg RPA-2 Powder Applicator A12950-XXX - Manual (Page 10)

RPA-2 Powder Applicator - Introduction
7 LN-9271-12.2
INTRODUCTION
GENERAL DESCRIPTION
This operating manual contains all important
information required for working with the RPA-
2 Powder Applicator.
It will give you refer-
ences and tips for the optimal use of your new
powder coating system.
The RPA-2 is intended exclusively for the
electrostatic coating with organic powders.
Any other use is considered as non-
conforming. The manufacturer is not responsi-
ble for any damage resulting from this; the risk
for this is assumed by the user alone.
With an integrated high voltage generator
(cascade), the RPA-2 is particularly suitable
for the coating of car bodies and parts. The
applicator is designed for operation on a freely
programmable hollow wrist robot (up to 7
axes).
The RPA-2 is installed on the front side of a
follow-arm coating robot. An appropriate
adapter piece for the corresponding robot type
is used for fitting the applicator to the robot.
This adapter provides a locating pin for exact
positioning of the applicator, as well as the
fixture of the applicator cable and hoses.
The RPA-2 has a high and constant transfer
efficiency.
The applicator is quick detachable, therefore
fast and easy for maintenance and repair.
The wear parts can be easily changed, even
with the applicator attached to the robot.