Ransburg Color Select System CCV-6100 - Manual (Page 10)

CCV-61XX-XXX - COLOR
SELECT SYSTEM
Includes the main box, top block, solvent valve
and 1/4 inch O.D. poly tubing. The solvent valve
is always supplied with a solvent proof check
valve and a 3/8-inch ODT stainless steel female
elbow for fluid inlet.
CCV-61(XX)-XXX - NUMBER OF
COLOR VALVES
(Selection 00-15). These two numbers indicate
the number of valves required for paint to the stack
assembly. Also number of color select boxes.
CCV-61XX-(X)XX - AIR PUSH
VALVES
(Selection 0, 1, 2). This number indicates the num-
ber of “air push” valves required. Each valve is
supplied with a solvent proof check valve; gauge,
regulator and 3/8-inch ODT brass push style fit-
ting for air inlet. The air push is used to push out
residual paint in the fluid supply line. This air is
also pulsed on and off with the solvent to create
a scrubbing action. In the event that two different
pressures are required, two air push valves can
be supplied.
CCV-61XX-X(X)X - CHECK VALVES
(Selection 0, 1). This number indicates whether
check valves are supplied on the paint inlet valves.
Check valves are used to prevent materials from
contaminating each other in the event that two
valves would be opened at the same time. NOTE:
Check valves will always be supplied on solvent
and air valves, regardless of selection made here.
CCV-61XX-XX(X) - FLUID INLET
FITTINGS
(Selection 0, 1, 2). This number indicates whether
no fitting, elbows, or tees are supplied for the fluid
inlet to the color valves. Elbows are typically
utilized for fluid inlet. Tees are used for circulat-
ing the paint at the color valve. The elbows and
tees are stainless steel and accept a 3/8-inch OD
fluid line.
All valves are supplied with a brass push style
swivel elbow for the air pilot. This fitting accepts
a 1/4-inch OD tube.
Color Select System - Introduction
8 CS-95-01.2
Ransburg