Ransburg Color Select System CCV-6100 - Manual (Page 14)

1 ---- Air Inlet, 1/8” NPT (F)
2 CCV-45 Clamping Nut *
3 VA-246 Cup *
4 CCV-3 Nut
5 CCV-41-K2 Spring Kit
6 CCV-4 Spring Washer
7 CCV-8-K2 Valve Needle Seal Kit *
8 ---- Fluid Inlet (2 ports), 1/4” NPT (F)
9 CCV-13 Spanner Nut
10 CCV-44 Ring Retainer
11 SST-8436-K5 Retaining Ring Kit
12 CCV-40-K2 Poppet Seat Kit *
13 CCV-39 Stem (Order KK-4841) *
14 SSP-1421 Pipe Plug (Shipped loose with valve)
(Not used if material is recirculated)
15 CCV-15-SS Valve Body
16 CCV-42 Valve Indicator
17 CCV-43 Valve Cap
18 ---- Use Adhesive (Medium Strength, Grade #242) on threads - 2 places
19 ---- Apply a thin film of lubricant (light grease) to bore and cup at
assembly.
-- CCV-7 Spanner Tool (Not Shown)
-- CCV-403-SS Color Change Valve Assembly
Color Select Box Assembly:
20 LPNE0005 Enclosure
21 LPNE0003 (Main Box) Bulkhead Faceplate (Front)
LPNE0006 (Secondary Box)
22 41-VMC-1002 Air Selector Switch
23 41-VAP-1004 Air Pilot Valve **
24 41-BAS-1000 Pilot Valve Base **
25 41-FBH-1000 Bulkhead Fitting
26 41-FTP-1015 Reducer Fitting, 1/4” T X 5/32” T (Not Shown)
27 LPNE0004 (Main Box) Bulkhead Faceplate (Side)
LPNE0007 (Secondary Box)
28 LS0079 Din Rail
29 LPNE0008 Mounting Plate
Item #
CCV-403-SS - PARTS LIST (Figures 3 and 4)
Part # Description
Torque Specifications
1. Tighten CCV-45 to CCV-3, with VA-246 in
between, using 12-18 lbs•in torque.
2. Tighten CCV-45, DDV-3, VA-246 assembly to
CCV-39 using 3 lbs•in torque maximum (finger
tight). DO NOT OVER-TIGHTEN.
3. Tighten CCV-43 to CCV-15-S valve body
using 75-125 lbs•in torque.
* Supplied in Repair Kit KK-4841.
** Main Color Select Box Only
Color Select System - Introduction
12 CS-95-01.2
Ransburg