Rivers Edge RE629 15' 2-Man Ladder Stand - Manual (Page 11)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 11
Operator's Manual
Rivers Edge Two-Man Ladder Stands
ASSEMBlY INSTRuCTIONS (RE615)
Tools needed – two 7/16" wrenches
IMPortant asseMblY tIP: do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! this will temporarily hold the lock nut on the bolt while
helping alignment of all parts! after all parts are assembled together, all nut
& bolt combinations must be completely tightened.
1. Attach two mesh foot platforms (2ML133) to the top (2) platform J-pipes
(2ML129) using (4) provided 1/4-20 x 2-1/2” bolts, locknuts, and (4) steel
washers. SEE FIGuRE 1. DO NOT tighten all nut & bolt assemblies
completely!
2. Bolt the two platform frames together using (2) provided 1/4-20 x 2-1/4”
bolts, locknuts, and steel washers. SEE FIGuRE 1.
3. Attach the tree blade (2ML130) to the top of platform J-pipes using (2)
provided 1/4-20 x 2-1/2" bolts, locknuts and steel washers.
SEE FIGuRE 2.
4. Attach the (2) side seat support loops (2ML93) to the rear platform using
(4) provided 1/4-20 x 2-1/4" bolts, locknuts, and steel washers.
SEE FIGuRE 3.
5. Attach the (2) flat bar braces (LL9A) to the back side of side seat support
loops and to the outside of rear platform using (4) provided 1/4-20 x 1-1/2"
bolts and locknuts. SEE FIGuRE 3.
Figure 1
Figure 2
1/4-20 x 2-1/2" bolts
washers
tree blade
platform J-pipes
locknuts
cutout view of
mesh foot platforms
locknuts
platform J-pipes
1/4-20 x 2-1/2" bolts
steel washers
locknuts
steel washers
1/4-20 x 2-1/4"
bolts
Figure 3
1/4-20 x 1-1/2" bolts
locknuts
1/4-20 x 2-1/4" bolts
steel washers
seat support loops
flat bar braces
rear platform