Rivers Edge RE629 15' 2-Man Ladder Stand - Manual (Page 19)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 19
Operator's Manual
Rivers Edge Two-Man Ladder Stands
9. Slide the (2) shooting rail J-pipes (411032) over the shooting rail
straight tube (411027) and secure together using (2) provided
1/4-20 x 1-1/2" bolts and locknuts. SEE FIGuRE 6.
10. Attach the previously assembled shooting rail to the tabs located
on the shooting rail extension tubes using (2) provided 1/4-20 x
1-3/4” bolts, locknuts, steel washers and nylon washers. You must
now tighten all nut and bolt combinations completely. Be
sure not to over tighten or crush tubing when tightening.
SEE FIGuRE 7.
11. a. Attach the removable seat cushion (48814) to the top of seat
frame. Wrap the Velcro seat straps or buckle straps around seat
frame and secure together. Snap the side release buckles together
for buckle style seats. Pull straps tight so seat is not loose. Attach
backrest portion by wrapping Velcro around backrest rail and
securing.
b. Attach the (2) provided 9” and (1) provided 36” camo foam
sleeves to the side loop frames and shooting rail by wrapping
around square tubing and attaching Velcro together.
12. Insert one side of the base extension weldment (410044) into the
base extension rail tube (410040) and secure with (1) spring lock
pin. Handle of spring lock pin must be put to the outside of long
rail. SEE FIGuRE 8.
13. Take the factory assembled ladder sections and unfold them to
their full, deployed width. Insert the previously assembled base
extension into (1) 3-step ladder section (410032). SEE FIGuRE 8.
This step now makes this the bottom ladder section.
Figure 8
Figure 7
Figure 6
locknuts
shooting rail J-pipes
shooting rail straight tube
1/4-20 X 1-1/2" bolts
locknuts
shooting rail
rail extension
tube tabs
1/4-20 X 1-3/4" bolts
locknuts
nylon washers
base extension weldment
base extension rail tube
spring lock pins
bottom ladder section
steel washers