Rivers Edge RE629 15' 2-Man Ladder Stand - Manual (Page 20)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 20
Operator's Manual
Rivers Edge Two-Man Ladder Stands
14. Sections are assembled on the ground in the following order;
bottom section (410032 ladder with assembled base extension);
second section (410035 ladder with stabilizer bar mount); third
section (410032 ladder); top section (assembled top platform
section). Make sure assembled ladder sections have the steps po-
sitioned on the same side (outward) for climbing. SEE FINISHED
15’ 2-MAN lADDER.
15. With all sections assembled together on ground, secure all sec-
tions together using (6) provided spring lock pins. Handle of
spring lock pin must be put to the outside of ladder side rails. SEE
FIGuRE 9. In total, you should now have 9 spring lock pins on the
ladder assembly that are securing all sections together.
16. a. Attach the stabilizer bar extension tube (1ML23) to the second
ladder section mounting bracket using (1) provided spring lock
pin. SEE FIGuRE 10.
b. Slide the stabilizer bar (L17) into the extension tube and attach
the two pieces together using (1) provided spring lock pin. Spring
lock pin must go through both the extension tube and stabilizer
bar at appropriate hole to achieve desired distance from tree.
Adjustment in length may be needed when ladder is uprighted
later in instructions. SEE FIGuRE 10.
17. a. Tie one end of the provided 9’ rope to the link welded onto the
stabilizer bar, just in front of the tree hugger. Be sure your double
knots are secure. SEE FIGuRE 11.
b. Tie one end of each of the provided 15’ ropes to the tree blade
extension tubes, just in front of the bolt-on tree blade. Be sure
your double knots are secure. SEE FIGuRE 11.
Figure 11
Figure 10
Figure 9
stabilzer bar
stabilizer bar extension tube
spring lock pins
spring lock pins