Rivers Edge RE629 15' 2-Man Ladder Stand - Manual (Page 17)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 17
Operator's Manual
Rivers Edge Two-Man Ladder Stands
ASSEMBlY INSTRuCTIONS (RE629)
Tools needed – two 7/16” wrenches
IMPortant asseMblY tIP: do not tIGHten nut & bolt coMbInatIons
coMPletelY untIl all Parts are asseMbled toGetHer! FInGer tIGHt-
en onlY Plus one turn oF a WrencH onlY! tHIs WIll teMPorarIlY Hold
tHe lock nut on tHe bolt WHIle HelPInG alIGnMent oF all Parts!
aFter all Parts are asseMbled toGetHer, all nut & bolt coMbIna-
tIons Must be coMPletelY tIGHtened!
1. Attach (2) ladder side J-rails (411018) to (1) welded platform frame
(411021) using (4) provided 1/4-20 x 2-1/4” bolts, locknuts and steel
washers. SEE FIGuRE 1. DO NOT tighten all nut and bolt assem-
blies completely!
note: Mesh surface of platform should be on top and rounded
corners of platform are orientated as per figure 1. this step now
makes this platform the seat platform.
2. Attach (2) side loop frames (411024) to the previously assembled
ladder side J-rails using (4) provided 1/4-20 x 2-1/4” bolts, locknuts
and steel washers. SEE FIGuRE 1.
3. Slide the flared side rail (411019) and the long flared side rail
(411020) over the previously assembled ladder side J-rails and
secure together using (2) provided 1/4-20 x 1-1/2” bolts, locknuts
and steel washers. SEE FIGuRE 2. Pay extra attention to which side
the long flared rail is assembled to as it will affect ladder assembly
later on in assembly instructions.
4. Attach the second welded platform frame (411021) to the flared
side rail, long flared side rail and both side loop frames using (2)
provided 1/4-20 x 2-1/4” bolts, (2) 1/4-20 x 2-1/2” bolts, (4) locknuts
and (4) steel washers. SEE FIGuRE 2.
Figure 2
Figure 1
ladder side J-rails
side loop frames
welded platform frame
steel washers
1/4-20 X 2-1/4" bolts
locknuts
1/4-20 X 2-1/4" bolts
steel washers
locknuts
flared side rail
long flared side rail
1/4-20 x 1-1/2" bolts
locknuts
steel washers
1/4-20 x
2"-1/4 bolts
1/4-20 x 2-1/2" bolts
steel washers
locknuts
second welded
platform
side loop frames