Rivers Edge RE602 JOURNEYMAN - Manual (Page 27)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 27
Operator's Manual
Rivers Edge One-Man Ladder Stands
ASSEMBlY INSTRuCTIONS (RE603)
Tools needed – two 7/16" wrenches
IMPoRtant assEMBlY tIP: do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! this will temporarily hold the lock nut on the bolt while
helping alignment of all parts! after all parts are assembled together, all nut
& bolt combinations must be completely tightened.
1. Attach the foot platform (1ML26) to the inside of side rails (SL61) using (2)
provided 1/4-20 x 2-1/4” bolts and locknuts. SEE fIGuRE 1. DO NOT tighten
all nut & bolt assemblies completely!
notE: Mesh surface should be on top with squared ends of platform clos-
est to side rails.
2. Attach the foot platform flat bars (SL8) to the inside of side rails and the
outside of foot platform using (4) provided 1/4-20 x 1-1/2” bolts and locknuts.
SEE fIGuRE 1.
3. Attach the seat/tree blade frame (SL24) and the rear end of armrests (AR12)
to the side rails using (2) provided 1/4-20 x 3” bolts, (2) 1/4-20 X 2-1/4" bolts,
(4) locknuts and (2) steel washers. SEE fIGuRE 2.
4. Attach the front end of each armrest to the side rails using (2) provided
1/4-20 x 2-1/4" bolts and locknuts. SEE fIGuRE 2. You must now tighten
all nut & bolt assemblies. Be sure not to over tighten or crush tubing
when tightening!
5. a. Attach the shooting rail by setting rail down over studs provided on
armrests. SEE fIGuRE 3. lubrication is recommended to prevent binding
and noise.
b. Attach the (2) provided 9” and (1) 18” camo foam pads to the armrests
and shooting rail by wrapping around tubing and attaching Velcro together.
6. Attach the removable seat cushion (48819) to the top of seat frame. Wrap
the velcro seat straps or buckle straps around seat frame and secure together.
Snap the side release buckles together for buckle style seats. Pull straps
tight so seat is not loose.
Figure 2
seat/tree
blade frame
Figure 1
1/4-20 x 2-1/4” bolts
locknuts
foot platform
side rails
foot platform flat bars
1/4-20 x 1-1/2” bolts
locknuts
side rails
1/4-20 x 3” bolts
locknuts
1/4-20 x 1-1/2” bolts
1/4-20 x 2-1/4” bolts
steel washers
WARNING
fOOT PlATfORM AND SITTING SECTION MuST AlWAYS
fACE ThE SAME DIRECTION, TOWARDS ThE TREE.