Securitron HHSR - Manual (Page 2)

PN# 500-16600
Page 2 Rev. D, 07/11
INCLUDED HARDWARE (Quantities shown are per single pack):
2X All Models 2X All Models 2X All Models
Phillips Head W/ Washer
#8 X 1/2” TEK
Socket Head Cap
1/4-20 X 1”
Blind Nut
1/4-20
8X -32 Models
2X -32 Models 4X -62/82 Models
9X -62/82 Models
Socket Head Cap
1/4-20 X 1-3/4”
Socket Head Cap
1/4-20 X 2-1/2”
Phillips Flat Head
#12 X 1-1/2” Type “A”
3. RECOMMENDED TOOLS
 Hammer
 Center Punch
 Drill Motor & Bits
 Phillips Screwdriver: #2
 Wrench, 1/2” Open-end (or adjustable)  Wrench, Hex, 3/16”
 Wire Strippers/Crimpers
 Pliers
 Metal File
4. INSTALLATION
Unpack the housing. Without disassembling, position the unit into its intended location to verify
that it is the correct length/height for the door opening. For the dual Magnalock models (HHD
and HVD), the lock/strike locations are equally spaced to each side of center of the housing as
shown. (All dimensions displayed in brackets [XX.X] are in millimeters).
Figure 1
HHD-32
HHD-62
HHD-82