Securitron M680BDCX - Manual (Page 14)

PN# 500-10560
Page 14 Rev. D, 07/12
Final Wiring
1.
Pull wires/cables through the wire feed-through hole(s) that are drilled in the frame. A small
screwdriver has been included to help make connections to the terminal blocks as required.
The end user and installer are liable for Fire and Building code compliance.
2.
The following diagram shows a basic wiring configuration for the Magnalock.
M680BDCX
3.
Motion Detector models: Enable the motion detector by locating DIP Switch SW2, and setting
Switch 5 to ON. REX timer is set with Switch 3. OFF= 5 seconds, ON= 10 seconds
Camera Models: Connect the camera to your security system using the included BNC cable.