Securitron DK-37 - Manual (Page 4)

PN# 500-20750
Page 4 Rev. A, 11/13
INDICATOR MEANING
Single short beep
 A button press; or
 Entry into Programming Mode
Single long beep
 While in normal operation (Wiegand Mode):
 User ID entered is greater than 65535 no transmission occurred; or,
 Six digits were entered; no transmission occurred
 While in Programming Mode:
 An error or non-acceptance of a new facility code has occurred
Double beep
 While in Programming Mode:
 Acceptance of a new facility code in Wiegand mode
 Changing mode from Wiegand to Character
Repeating Short Beep  A button is being held down and/or is stuck
When entering a sequence the DK-37 has a 5 second timeout that will erase the internal buffer
when a key is not pressed within 5 seconds. For example, if the correct code is 2-2-6-7 and the
user enters 2-2-6 followed by a 5 second delay and then enters 7 the DK-37 will not unlock the
door.
Keypad Operation
DK-37 keypads are shipped from the factory in ‘Wiegand mode’ of operation. To change the
facility code or mode of operation, follow the steps below:
Entering into Programming Mode
1. Remove power from the keypad.
2. At the DKC, temporarily connect the ‘LED-Y’ terminal to the ‘( - )’ terminal.
3. Apply power to the DKC and the yellow light will be on.
4. Without touching the keypad wait 5 seconds and the keypad will produce a single short beep
to indicate that programming mode has been entered.
Changing to Character Mode
1. Enter into programming mode (see above).
2. Within 30 seconds press the ‘#’ key and the DK-37 will beep twice. Programming
mode will automatically exit.
3. Remove the temporary wire connecting the ‘LED-Y’ terminal to the ‘( - )’ terminal.
4. Remove power from the DKC for 10 seconds.
Change to Wiegand mode and set facility code
1. Enter into programming mode (see above).
2. Within 30 seconds, enter a valid facility code of 1 to 3 digits in length. The code cannot be
greater than 255.
Note: If more than 3 digits are entered programming mode will automatically
terminate with an error.
3. Press the ‘*’ key and the DK-37 will beep twice. Programming mode will automatically exit.
4. Remove the temporary wire connecting the ‘LED-Y’ terminal to the ‘( - )’ terminal.
5. Remove power from the DKC for 10 seconds.
In Wiegand Mode a valid user ID must be 1 to 5 digits in length and the ID cannot be greater
than 65535. If more than 5 digits are entered or if the ID entered is greater than 65535 an
audible error will sound, the buffer will be cleared, and no transmission will be sent. A valid user
code must be followed by pressing the ‘’ key.
Technical Support
For general questions concerning this or other Securitron products please visit the Securitron
website www.Securitron.com or contact Securitron Technical Support at (800) 624-5625 or
email [email protected].
For MAGNACARE  Lifetime Replacement Warranty information please visit:
www.Securitron.com/en/site/securitron/About/MagnaCare-Warranty/