Securitron CEPT - Manual (Page 3)

PN# 500-22115
Page 3 Rev. C, 05/11
Electrical
The following chart shows the electrical specifications for each CEPT model.
MODEL TYPE WIRE SIZE/QTY CURRENT LIMIT (Per Wire)
18 AWG/2 Max. 5A
CEPT-10 10 Wire (2+8)
22 AWG/8 Max. 1A
EL-CEPT ElectroLynx® (8+4) 22 AWG/12 Max. 1A
24 AWG/8 Max. 1A
CEPT-C5E CAT 5e (8+1)
22 AWG/1 Ground (Max. 1A)
INSTALLATION INSTRUCTIONS
NOTE: The CEPT should always be mounted above the second hinge from the floor.
The CEPT was designed primarily to be installed into a factory prepped door and frame.
However, the unit can be installed into an un-prepped door and frame by following the specific
instructions provided on the product installation diagram. The following exploded illustration
shows the included hardware required to properly install a CEPT to a factory prepped door
opening (CEPT-10 shown).
To install the CEPT to a factory prepped door and frame:
 Route/pull utility wires/cable through the prepped holes in door and frame.
 Pop out the desired knock-out hole in the back box.
Notes:
1. Back boxes are normally required to meet fire code requirements.
2. The 7/8” diameter knock-out holes in the back boxes are provided for EMT type
electrical conduit fittings.
3. The 5/8” diameter knock-out holes are for use of the provided strain relief bushings.
 To install the strain relief bushing, lay the utility cable (not included) into the slotted
opening in the bushing allowing a sufficient wire length (loop) for making connections.
Fold the hinged retainer over the cable, squeeze together using pliers and then insert
through the 5/8” [15.9mm] knock-out in the back box.
(Prepped) Door (Prepped) Frame
Back Box(es)
CEPT