Securitron CEPT - Manual (Page 4)

PN# 500-22115
Page 4 Rev. C, 05/11
 When required, install the appropriate connectors for ElectroLynx® or CAT 5e (not
included) to the end of your utility cable.
 Using a #2 Phillips screwdriver, attach each back box to the door and/or frame using the
10-24 x 3/4” long screws (for metal) or the #10 x 3/4” long screws (for wood). These
screws are to be placed through the center hole in each flange of the back box.
Metal Door Prep. Wood Door Prep.
 Make connections to the CEPT by:
o
Using the connectors (EL-CEPT or CEPT-C5E models).
o
Using the provided wire nuts for connection of the two (2) 18 AWG wires - and by
using the Dolphin™ (crimp type) connectors to make the appropriate connections to
the remaining 22 AWG wires (CEPT-10 model).
 Using a #2 Phillips screwdriver, assemble each side of the CEPT to the door and frame
using the 10-24 x 3/4” long screws (for metal) or the #10 x 3/4” long screws (for wood).
These screws are to be placed through the four corner holes in the face flange of each of
the CEPT housings and also through the outer (clearance) holes in the back box.
MAGNACARE  LIFETIME REPLACEMENT WARRANTY
For warranty information visit www.securitron.com/en/site/securitron/About/MagnaCare-Warranty/
Back Box Back Box
CEPT
10-24 X 3/4”
CEPT
#10 X 3/4”