Setting up the emulator hardware, Te-tle true loop emulator equipment list, The interface – Hochiki TE-TLE User Manual
Page 7: Equipment included, Equipment required (not supplied)
Hochiki TE-TLE True Loop Emulator – User Manual
7
Hochiki Europe (UK) Ltd
2-3-0-416/Mar04/Iss3
Setting Up the Emulator Hardware
TE-TLE True Loop Emulator Equipment List
Equipment Included
The following items are supplied within the TE-TLE package. Please unpack the system and
check that all of the following are included:
True Loop Emulator module (box)
Serial Cable (for connection to PC)
Power Supply Unit (PSU) supplying an output of 12V DC from an input range of 190-
264V AC at 65mA - for use in Europe only. For USA, use PSU Model WP1112-760'
supplying an output of 12V DC from an input range of 100 - 240V AC.
Hochiki TE-TLE True Loop Emulator - User Manual (this manual)
Hochiki TE-TLE True Loop Emulator - Software CD-ROM
Equipment Required (not supplied)
Wiring to connect the TE-TLE to a suitable control panel
PC or laptop required to run the emulator software
NOTE: The 3-pin plug supplied with the PSU is of the UK type. Please use an appropriate
adapter if using the TE-TLE outside of the UK. Please ensure that only the supplied
PSU (or the specified PSU for the USA, as above) is used with the TE-TLE. Hochiki
Europe accepts no liability for damage caused by using any form of power supply
other than that supplied or specified.
The Interface
The ‘Interface’ is the box or module that interfaces between the computer running the True
Loop Emulator
program and a Control Panel. However, it is more than just an electrical
interface; it contains a microprocessor that carries out much of the processing of the system.
The Interface has eight pairs of terminals grouped into four loops and eight LED's, one for
each pair of terminals. The function of the LED's varies as described below.