IAI America LSAS-N15HM - Manual (Page 13)

Pre-7
1. Handling the Actuator by It self
1.1 Handling the Packed Actuator
Unless otherwise specified, the actuator of single-axis configuration is packed individually.
When transporting or handling the packed actuator, exercise due caution not to hit the package against
other object or drop the package.
If the package is heavy, the operator must not attempt to carry the package alone.
When setting down the package, place it horizontally.
Do not step onto the package.
Do not place on the package any heavy object or other article with an area of concentrated mass that
may cause the package to deform.
1.2 Handling the Unpacked Actuator
When handling the unpacked actuator, hold it by the base.
Warning
Do not apply excessive force to any part of the actuator. Particularly, do not carry the actuator by holding
the cables, cable track and slider.
This actuator uses a high performance rare earth permanent magnet. Accordingly, do not approach near
the actuator if you use a medical device such as a pacemaker.
Handling precaution for the stainless sheet
The stainless sheet has a thickness of only 0.1 mm or so in order to provide flexibility. Because of this very
thin design, the stainless sheet easily gets dented and scratched. If the damaged stainless sheet is used
continuously, the sheet may eventually break.
Taboos in transportation
Do not transport the actuator by holding its slider. Do not transport the actuator by holding its cables.
Do not transport the actuator by holding its cable track. Do not transport the actuator by holding its stainless sheet.
Handling Precautions