IAI America LSAS-N15HM - Manual (Page 65)

13. Replacement/Adjustment of Stainless Sheet
49
13. Replacement/Adjustment of Stainless Sheet
13.1 N10SS, N10SM, N15SS, N15SM, N15HS, N15HM
[Required Items]
x Replacement stainless sheet
x Hex wrench set
x Scale
x Adhesive tape
[Notes]
1. Stainless sheet tension
Improper tension of the stainless sheet can promote deterioration and wear of the sheet.
If the tension of the stainless sheet is too taut and the clearance from the slider cover becomes greater
than 1 mm, it may cause the stainless sheet to undergo fatigue failure.
On the other hand, excessive slacks cause the stainless sheet to contact the back of the slider cover.
2. Checking the clearance between the stainless sheet and the back of the slider cover
The slider cover need not be removed when replacing and adjusting the stainless sheet.
Simply remove the inspection cover located on one side of the slider cover, and you can adjust the
stainless sheet by directly measuring and checking the clearance between the stainless sheet and the
back of the slider cover.
[Name of each part]
Stainless sheet retainer plates
Inspection cover Slider cover Stainless sheet