Foredom K.1050 - Manual (Page 5)

Set-up and Electric Connection
1. Fix the Handpiece Holder 22 to the right side of the
Control Unit with screw and washer. (Fig.7).
2. Plug the Handpiece Motor Cord 20 into the Handpiece
Motor Connector 13 located in the rear of the Control
Unit and then tighten the plug nut. (Fig.8).
3. Plug the Foot Pedal Cord 25 into the Foot Pedal Outlet
14 located in the rear of the Control Unit. (Fig.8)
4. Plug the Power Cord 26 into the Power Connector 15
in the rear of the Control Unit. (Fig.8).
CAUTION
Make sure that all cords are connected safely and
properly and that the Power Switch is off before
plugging in the Power Cord.
It is convenient to store burs on the surface of the
magnetic bur holder strips located on the side of
the controller. Some burs do not contain enough ferrous
metal to attach to the magnet. (Protect from ferrous
metal dust.) (Fig. 9).
Operation
a. Make sure that a bur is inserted in the motor
handpiece and collet is fully closed.
b. Set Power Switch 12 to off.
c. Plug the Power Cord 26 into a grounded
electric outlet.
d. Set the Speed Control Knob 7 to the
slowest position.
e. Turn on the Power Switch 12.
f. Select the rotation direction by pressing
Forward/Reverse Selector Switch 8.
CAUTION Never switch rotation direction
while the handpiece is running.
Hand Mode Operation , follow steps a. through f. above, then:
1. Press the Hand/Foot Selector Switch 10 to “Hand”.
(Hand/Foot Selector indicator light 11 lights up green.)
2. Press the Motor On/Off Switch 3 to run the motor. (Motor On/Off indicator light 4 lights up green.)
3. Set the Speed Control Knob 7 to desired speed.
4. Use the Motor On/Off Switch 3 to stop the motor.
Foot Mode Operation , follow steps a. through f. above, then:
1. Press the Hand/Foot Selector Switch 10 to “Foot”. (Hand/Foot Selector indicator light 11 lights
up orange, Motor On/Off indicator light 4 lights up green.)
2. Set the Speed Control Knob 7 to desired maximum speed.
continued
3
4
7
8
9
6
5
11 10
25
14
22
20
26
15
13
12
4