Foredom K.1050 - Manual (Page 7)

CAUTION
•
Do not exceed the maximum operating speed of the bur or accessory in the handpiece
to avoid personal injury.
•
Before turning off the Power Switch, make sure that the motor has been stopped.
•
When the unit is not in use, for maximum safety, unplug the Power Cord.
Rotation Speed Display Set Mode
NOTE: Use this set mode only when you wish to operate the micromotor handpiece with
a lower maximum RPM rating.
This function is for setting a safe maximum rotation speed of the handpiece.
a.Turn on the Power Switch 12 while pressing the Motor On/Off Switch 3 and wait for a
beep. Release the Motor On/Off Switch.
b. Set the maximum speed of the motor handpiece which you want to use by repeatedly
pressing the Hand/Foot Selector Switch 10.
c. Return to the main mode by pressing the Motor On/Off Switch.
Motor On/Off Switch Hand/Foot Selector Switch
“bc” displayed (Motor Handpiece) 25, 30, 35, 40, 45, 50 (x 1,000 rpm)
Maximum Torque Set Mode
This setting is used to match the maximum output of the control unit to the maximum
torque capability of the handpiece, or to prevent damage to the bur. The maximum
torque setting is preset at the factory to the recommended value. Use this procedure only
if you are using another motor handpiece with a lower torque rating, or if you are using
a bur which may be damaged by the full torque capability of the handpiece.
a. Turn on the Power Switch 12 while simultaneously pressing Forward/Reverse Selector
Switch 8 when you hear a beep, release the Forward/Reverse Selector Switch.
b. Set the electric current (ampere) value for maximum torque of the motor handpiece by
pressing Hand/Foot Selector Switch 10 repeatedly until the desired amperage value is
displayed. The higher the current value, the more powerful the torque.
Fwd/Rev Switch Hand/Foot Selector Switch Recommended
“c1” displayed 1a, 2a, 3a, 4a, 5a, 6a, 7a Up to 6a
CAUTION
•
Do not select a current value which exceeds the rating of the motor handpiece. Too high
a rating may shorten the motor life or damage the control unit. (Consult a qualified
technician if possible.)
Note – To check the values of maximum rotation speed and maximum torque which are
already set, turn on the Power Switch 12 while simultaneously pressing the Auto Cruise
Switch 5. The Set values are shown on the Speed Display LED 2 consecutively.
6