IntelliTrack WMS – Warehouse Management System - Manual (Page 23)

Quick Start Guide
19
To install the workstation application, please refer to the following instruc-
tions:
(Please note that your IntelliTrack software setup is on 2 CDs. Follow the
prompts in the installation wizard for switching between CD #1 and CD #2.
To install IntelliTrack software, you must have administrative privileges at
the PC.)
1. Insert CD #1 in the CD-ROM drive. Browse to the WMSSetup.exe file
on the CD and double-click on it to begin WMS setup.
2. The Welcome window appears, welcoming you to IntelliTrack WMS
v8.x. Click Next to continue.
3. The Select Components windows appears. From the Select Compo-
nents window, select Workstation from the options available. This will
only install the WMS Workstation application on this machine. When
you are ready to continue, click Next.
4. The Required Software needed for IntelliTrack WMS appears. This
window informs you that WMS requires Windows Installer 4.5 and
.NET Framework 3.5 with Service Pack 1.
• When you click Next, the setup will check for Windows Installer
4.5 and .NET Framework 3.5 Service Pack 1 on the PC.
• If both Windows Installer 4.5 and .NET Framework 3.5 with Ser-
vice Pack 1 are not detected, setup install Windows Installer 4.5
when you click Next. After installation, a reboot of your PC is
required.
• After the PC reboots, you must enter WMS setup again by browsing
to the WMSSetup.exe file on Disk #1. Double-click on the WMS-
Setup.exe file to reenter WMS setup.
• Follow the prompts through the installation setup wizard until you
reach the Required Software needed for IntelliTrack WMS screen
again. Click Next at this screen. If .NET Framework 3.5 Service
Pack 1 is not detected on your PC, a message appears telling you
that .NET Framework needs to be installed. Click OK to install it.
An Insert Installation Disk #2 dialog appears, prompting you to
install Disk #2 and then click OK. Setup extracts the .NET Frame-
work installation files and installs .NET Framework. This may take
several minutes. After installation, a reboot of your PC may be
required. After the reboot, remove Disk #2 from the CD-ROM drive