Emc statements ‐ fcc part 15 notice, Ices‐003, Declaration of conformity request – JuiceGoose NXRT Series User Manual

Page 3: Caution, Warning

Advertising
background image

NXRT‐1000, NXRT‐1500, NXRT‐2000, NXRT‐3000 USER’S MANUALUNINTERRUPTIBLE POWER SUPPLY (UPS) 

EMC Statements ‐ FCC Part 15 

Notice: 

Pursuant to section 15 of the FCC rules, this product has been tested and thereby complies 

to  the  conditions  of  a  Class  B  (NXRT‐1000,  NXRT‐1500)  and  Class  A  (NXRT‐2000,  NXRT‐3000)  digital 
device, which have been established for offering sufficient protection against dangerous interference for 
installation  in  a  residential  area.  Installation  and  use  of  the  equipment  should  comply  with  the 
instructions provided in order to avoid such interference due to the amount of radio frequency energy 
that  is  radiated  and  generated  by  the  equipment.  In  spite  of  this,  we  cannot  assure  that  a  certain 
amount of interference may not occur in some installations. If, by turning on and off, it can be deduced 
that  your  radio  or  television  reception  is  found  to  be  influenced  by  harmful  interference  from  the 
equipment, it is recommended to use one of the following preventive measures. 

• Place the receiving antenna in a separate location or orientation. 
• Ensure a greater distance is achieved between the receiver and the equipment. 
• Ensure  that  your  equipment  is  connected  to  an  outlet  on  a  separate  circuit  than  the 

receiver. 

• Contact a technician experienced with radio and TV or a dealer for further assistance. 

ICES‐003 

This  Class  B  Interference  Causing  Equipment  meets  all  requirements  of  the  Canadian  Interference 
Causing  Equipment  Regulations  ICES‐003.  Cet  appareil  numerique  de  la  classe  B  respecte  toutes  les 
exigencies du Reglement sur le materiel brouilleur du Canada. 

Declaration of Conformity Request 

Units labeled with a UL mark comply with the following standards and directives: 

• UL 1778 

CAUTION: 

A  shielded‐type  power  cord  is  required  in  order  to  meet  FCC  emission  limits  and  to 

prevent  interference  to  the  nearby  radio  or  TV  reception.  It  is  essential  that  only  the  supplied  power 
cord be used. Use only shielded cables to connect I/O devices to this equipment. 

WARNING: 

Any  changes  or  modifications  not  expressly  approved  by  the  manufacturer  of  this 

device could void the user’s authority to operate the equipment. 

 [3] 

Advertising