KB Electronics IODA, Input/Output Module for use with all KBDA/KBMK Controls - Manual (Page 10)

10
3.4 INSTALLING THE IODA INTO THE DRIVE
Place the IODA in the area where it is to be installed. Be sure the ribbon cable is
routed underneath the mounting base. Align the two snap-ins of the mounting
base with the two holes on the KBDA PC board and press firmly until the
mounting base is secured onto the KBDA PC board. See Figure 6.
Use the 6-32 X ½" and 6-32 X 1" screws for the small Mounting Base (see Figure
8, on page 11). Use the two 6-32 X 1½" screws for the large Mounting Base (see
Figure 9, on page 12). Use the Allen Key (supplied) to tighten the screws. Do
not over tighten.
Note: To facilitate the connection of the ribbon cable onto the IODA, it is
recommended that the fold of the ribbon cable be positioned in the area where
the IODA and mounting base will be located, as shown in Figure 6.
FIGURE 6
INSTALLING THE IODA INTO THE DRIVE
*Model KBDA-24D shown. Layout of Models KBDA-27D, 29, 45, 48 varies slightly.
3.5 INSTALLING THE RIBBON CABLE
Install the Ribbon Cable Connector,
located in the middle of the Ribbon
Cable, into the Mating Connector
CON1 on the IODA PC board. Align
the Connector Key with the Key Slot
and push down until fully engaged.
See Figure 7.
FIGURE 7
INSTALLING THE RIBBON CABLE
INTO THE IODA CON1