KB Electronics KBMM-225D - Manual (Page 14)

6.3 Permanent Magnet (PM) Motor Connection – Wire the motor armature positive lead (+) to Terminal “A+”
(Armature Fuse) and the negative lead (-) to Terminal “A-”, as shown in Figure 1, on page 10. On Models
KBMM-225 and KBMM-225D, be sure Jumper J2 is set to the corresponding motor voltage, as described
in Section 7.2, on page 20. Be sure the correct Plug-In Horsepower Resistor® is installed, as described in
Section 9, on page 21.
6.4 Motor Field Connection (Shunt Wound Motors Only)
6.4.1 Full Voltage Field – Wire the field positive (+) lead to Terminal “F+” and the negative lead (-) to
Terminal “F-”, as shown in Figure 1, on page 10, and as described in Table 4.
6.4.2 Half Voltage Field – For 90 Volt DC motors with 50 Volt DC fields and 180 Volt DC motors with 100
Volt DC fields, wire the field positive lead (+) to Terminal “F+” and the negative lead (-) to Terminal “L1”
(Line Fuse), as described in Table 4.
Notes: 1. Do not connect motor armature leads to Terminals “F+” and “F-”. 2. Do not use Terminals “F+”
and “F-” for any purpose other than to power the field of a shunt wound motor. 3. Shunt wound motors
may be damaged if the field remains energized without armature rotation for an extended period of time.
14
Model AC Line Input Voltage (Volts AC) Armature Voltage (Volts DC) Field Voltage (Volts DC) Terminal Connections
KBMM-125 115 0 - 90
100 F+, F-
50 F+, L1
KBMM-225 208 / 230
0 - 180 200 F+, F-
0 - 90* 100 F+, L1
KBMM-225D
115 0 - 90
100 F+, F-
50 F+, L1
208 / 230 0 - 180 200 F+, F-
208 / 230 0 - 90* 100 F+, L1
TABLE 4 – FIELD CONNECTION (Shunt Wound Motors Only)
* Step-down operation.