ADC Modem MM701G - Manual (Page 12)

Checking LED Indications
6 MM701G User Manual
C
HECKING
LED I
NDICATIONS
Your service provider sets up the G.shdsl parameters for your service. The MM701G must have
the DSL SYNC LED lit before you can connect sessions with your service provider. Verify
SYNC in the following table.
The table below describes LED indications for all operational modes. LEDs on the MM701G
front panel provide continual status at-a-glance for network and voice connections.
LED State Description
POWER On green MM701G has power.
Off MM701G does not have power.
Ethernet
LINK On green A PC, hub, or other network device is connected to the MM701G
10Base-T interface.
Off No device is connected to the MM701G 10Base-T interface.
Tx Flashing green MM701G is transmitting data to devices on the LAN.
Off MM701G is not transmitting data to the LAN.
Rx Flashing green MM701G is receiving data from devices on the LAN.
Off MM701G is not receiving data from the LAN.
Coll Flashing green Ethernet packet collisions are occurring on the LAN.
Off No Ethernet packet collisions are occurring.
DSL
Sync On green DSL transceiver is synchronized (connected) and in normal operation
mode.
Flashing green Slow flashing green indicates that the DSL transceiver is in a start-up
or handshaking sequence. Fast flashing green indicates that the DSL
transceiver is in training sequence.
Off DSL transceiver is not detecting a transceiver at the far end and is not
connected.
Tx Flashing green MM701G is transmitting data over the DSL connection.
Off MM701G is not transmitting data over the DSL connection.
Rx Flashing green MM701G is receiving data over the DSL connection.
Off MM701G is not receiving data over the DSL connection.
Margin On green DSL margin is above the preset margin value.
Off DSL margin is at or below the preset margin value.