LEESON Mounting Instructions for FHP Series - Manual

The FHP Series PCM Adder Board 175324.00 accepts a 0 - 5 VDC, 0 - 10 VDC, or 4-20
mA signal and outputs an isolated 0-5 VDC signal without requiring additional panel
space. It mounts directly over the main AC board (bottom board) thus maintaining the
same footprint. This instruction manual will give you step-by-step information for
successfully mounting the PCM Adder Board to your FHP Series drive.
The following diagram shows a FHP Series drive with the PCM adder board installed onto
the unit and the parts supplied in this kit.
MOUNTING INSTRUCTIONS
FOR FHP SERIES PCM ADDER BOARD
6-PIN
HEADER (1)
6-32 x 1 5/16"
PHILLIPS SCREW (1)
0.578" NYLON
SPACER (1)
SHOULDER
WASHER (1)
PCB
STANDOFF (2) JUMPER (1)
PCM ADDER
BOARD (1)
S1 S2 S3 E 1 D
J501
1:0-5VD
C
2:0-10VD
C
3 :4-
20M JMP5
02
:INPUT TYP
E
TB5
01
2-3:
C URREN
T
1-2:V
O LTA
GE
PARTS SUPPLIED IN THIS KIT
Required Tools: Phillips Screwdriver
MAIN AC BOARD
(BOTTOM BOARD)
TB501
Y U W
J501
C501
C502
TH501
L 1
L 2
230
V
D
JMP5
02
:INPUT TYP
E
2-3:
C URREN
T
1-2:V
O LTA
GE
PCM ADDER
BOARD